tmack
NEWBIE MEMBER
Posts: 19
|
Post by tmack on Jun 7, 2009 15:27:31 GMT -6
What is the distance to mount the ball on the servo arm for cyclic? Not all of the arms have the same number of holes. Is the distance 13mm? I heard Finless mention 13mm from the center of the mounting hole in one of his videos but, I've yet to come across any other referance. Not even is the Trex manual. Thank you.
|
|
|
|
Post by Solitaire on Jun 7, 2009 16:03:18 GMT -6
I don't know if this is right or not, but I like to get as straight a shot as I can from the servo horn to the swash. If you are using all the same servos on the cyclic, the horns should be identical.  |
|
tmack
NEWBIE MEMBER
Posts: 19
|
Post by tmack on Jun 7, 2009 16:08:03 GMT -6
Ok, I know if I go out further on the arms I'll have more travel and I'll have to lower my end point on the TX. So should I try to get the straightest shoot with the most travel?
|
|
tmack
NEWBIE MEMBER
Posts: 19
|
Post by tmack on Jun 7, 2009 16:13:31 GMT -6
Keeping all of the swash arms the same distance? I'm afraid I'm not getting enough travel. I could be wrong, it just doen't look like the washout is moving that far on the main shaft. I'm still waiting on my new TX/RX to check it out, right now I'm just moving it buy hand and trying to get it close.
|
|
McKrackin
First 30 Member 
First 30 Member
Flippin' the bird!
Posts: 3,720
|
Post by McKrackin on Jun 7, 2009 17:22:40 GMT -6
Just try to get about 10 degress of pitch +/-
|
|
tmack
NEWBIE MEMBER
Posts: 19
|
Post by tmack on Jun 7, 2009 17:26:09 GMT -6
Ok, thanks.
|
|
