wild tail on the hk450

[fireheli]

hi guys, i'm finally done with all the training and i get to play with my heli's again.
the hk450 is built. but.... i don't know if i have the dx6i programmed right, or it might be the gyro, or....it might be me.
when i spooled it up, the tail spun to the right (heli going left). so i thought i would adjust the tail servo to compensate. to get it to hold i had to pretty much put it to the limit. so my question is this. do i need to adjust the gain more? also, what does the atv screw do? btw, it's a telebee headlock and standard dual rate
#gr302-ad thanks

[akent]

Sorry Fire, but I don't know anything about that gyro.
I did however find the manual. The ATV is the servo extent adjustment. turn that until the servo just makes it to the end of the tail travel without binding.

With some gyros, you have to set them up in rate mode with low gain settings and you move the servo forward and back to get it steady. Then when you switch on HH mode, they will hold. The Esky 0704B is that way.

But, I don't know about your Telebee.

Best,
Kent