The only Gasser Conversion Kit to spin 800mm Blades
Some of the key features:
Designed for Zenoah RC Series Engines (G230RC to G270RC or CY Zenoah Clone Engines)
Excellent Balance and Performance
Exactly the same size frame as Trex-700
No Vibrations
2.3mm thick G10/FR4 Highest quality material used for side frames and Fan shroud mount
3.2mm thick G10/FR4 Base Plate
6.5mm thick G10/FR4 Engine Mount Plate
Relocated Throttle Servo
Relocated Tail Servo
Trex 700 Stock Gear Ratio (Plz use Trex700 Mod-1 Gear Upgrade)
This kit uses all stock parts from Align - There is nothing you need with this kit
Note: Due to a little diameter difference in the Torque tube, it is required to wrap two rounds of paper tape on the edges of the Tail boom for better grip. Also, Helibug Recommend to Consider Upgrades for the Trex700 like KDE Main Shaft Bearing Block, Lynx Clutch and Align Mod-1 Gear upgrade etc.
Kit Includes :
1. Main Frames with Bearings
2. Base Plate
3. Clutch mount w/ Engine Screw
4. Engine Mount plates with screws
5. Carbon Fiber 21.15mm Tailboom
6. Single Piece T6061 Aluminum Torque Tube
7. Throttle Servo Plate
8. Tail Servo Plate
9. Front Frame Mount
Price: $324.99
Conversion Steps
There is nothing special in converting Trex 700 to Helibug Mercury 800 with this conversion kit. The only addition from the manual is mounting the RC Engine. Below is the step-by-step pictures as installation instructions
Install Front Frame Mount on Engine Mount Plate
Install Engine Mount Plate on the RC Engine
Install Clutch Mount on the Engine
Base Plate on Landing Skids
Its Highly recommended to use Lynx Clutch on this Conversion Kit
Stock Trex 700 14T Pinion
Single Piece T6061 Aluminum Shaft Machined on both sides
Excellent Fit in the Tail Gear
Use Paper tape - Two Rounds
Use Paper tape - Two Rounds
After installing Stock Torque Tube Bearings, put the shaft in the Tail Boom
WARNING: The radio controlled model helicopter built from this conversion kit is not a toy and is not meant for children. It is a flying machine capable of causing property damage and serious bodily harm to both the operator/assembler and/or spectator if not built and operated correctly and responsibly. Rotating components, especially the main rotor blades, are an ever-present danger. Model helicopters operate differently than model cars and airplanes. Helicopters by their nature are not positively stable, meaning that even if properly assembled and adjusted, helicopters will not recover from an unwanted flight attitude, nor will they hold any particular orientation without constant control inputs from the pilot.
IT IS YOUR EXCLUSIVE RESPONSIBILITY TO PROPERLY BUILD, MAINTAIN AND OPERATE HELICOPTER.
HELIBUG has spent considerable time making this product reliable and easy to build, but only the operator can insure that it is safe. Because the safe operation of this helicopter is beyond the control of the Manufacturer and distributor, the owner/operator assumes all risk of use.
. Very nice!!!
