Raygun
Moderator 
FIRST 30 MEMBER
The needs of the many out weigh the needs of the few
Posts: 1,567
|
Post by Raygun on Aug 20, 2011 15:25:37 GMT -6
Have you ever needed a tool and did not have time to order it here are some of my crude home brewed tools to maybe help you out in a pinch. Quit laughing Dave they all work well!!! Attachments:
|
|
Raygun
Moderator
FIRST 30 MEMBER
The needs of the many out weigh the needs of the few
Posts: 1,567
|
Post by Raygun on Aug 20, 2011 15:30:58 GMT -6
The ball link tool is made from a cheap pair of flat or needle nose pliers ground with a slot and a screw tapped in to push against the ball link.
The gear removing tool can be purchased at any home improvement store in the electrical department as a hanger for lights and other stuff off of I beams. It also was ground down and a pin was installed in the bolt.
The blade balancer was made from scrap aluminum and some bearings out of old motors. The level is an old line level cut down it works pretty good.
|
|
|
|
Post by Dave on Aug 20, 2011 16:22:10 GMT -6
Not laughing here Raygun, all I want to know is why in the heck you haven't put them on the market.
|
|
Raygun
Moderator
FIRST 30 MEMBER
The needs of the many out weigh the needs of the few
Posts: 1,567
|
Post by Raygun on Aug 20, 2011 19:22:54 GMT -6
Sure Dave I know what your thinking you could get the whole world laughing at me  |
|
|
|
Post by coffinsnail on Aug 21, 2011 1:11:06 GMT -6
Here is my tool for holding onto my heli when i have to work on it upside down, or at least close to upside down, plan to reinvent it this winter  and i might just sell it to.  |
|
and i might just sell it to.