|
|
Post by elkmaster01 on Mar 20, 2009 12:14:57 GMT -6
I have the Genesis 450 PE. I am changing all three rotor servos. While clipping the zip-ties and sliding out the Rx two clips came out before I could see exactly their position. I've changed the servos and got the wiring on two of them correct. What I have left is the forward left servo wires and one single wire clip from the head-lock gyro. So far the wires on the Rx are, starting from the right-helicopter side, are 1-forward right rotor servo,,,2- the aft rotor servo,,3-ECS wires,,,4-head-lock gyro. Now I have 3 open channels on the Rx. I 'suspect' the single wire from the head-lock gyro came off channel 5 hooked to the forward pin,,,correct? And the wires from the forward left rotor servo in channel 6,,,correct?? that would leave channel 7 open,,,correct??
I need to make sure of these last two connections before I zip-tie everything back in.
HELP!!
Randy
|
|
McKrackin
First 30 Member 
First 30 Member
Flippin' the bird!
Posts: 3,720
|
Post by McKrackin on Mar 20, 2009 14:39:20 GMT -6
What kind of RX?
|
|
|
|
Post by elkmaster01 on Mar 20, 2009 15:02:04 GMT -6
Mc,,
I got it,,,finally got thru to xheli tech sup. Channel 5 is the single wire from the head-lock gyro plugged into power pin of ch 5. Channel 6 was the fwd left cyclic servo. So far all checks out. I'm zip-tie-ing everything then I'll have to set servo horns and check swash leveling then blade angles.
I'll be on the test stand in the morning!! ;D
|
|
McKrackin
First 30 Member
First 30 Member
Flippin' the bird!
Posts: 3,720
|
Post by McKrackin on Mar 20, 2009 15:17:13 GMT -6
Glad to hear it ;D
|
|
